Corrugated Box Making Machine For Carton Stripper,Carton Waste
The carton stripper provided a safe economic solution for stripping your waste paper of die cut sheets ,however cardboard or corrugated board
The waste stripper is equipped with multi tooth chain drive by a compressor air motor with an output 2500rpm, its teeth do not cut the paper ,they catch it , your operator smply need to hold the device. The waste stripper quickly finished the his work , up to 10times than by hand
For waste margin stripping of cardboard, thin corrugated paper and common corrugated paper in printing industry, High-speed running gear is cycle driven through air motor , strip waste margin paper with sharp teeth gear. The gear use high strength Diamond Compound after heat treatment, high hardness, wear resistance, long life and easy replacement .
The product is high efficient manual stripping equipment, stripping efficiency is improved by 10 times, manual stripping needs hours, finished only in 10-30 minutes with stripping machine, greatly shorten the delivery cycle.
Compact configuration,almost the same weight as normal grinder,easy to use,worker can operate the machine after simple training, No damage for bonding area while stripping,improve the efficiency of the following process (gluing / automatic packing)
Instructions for use
1. Pneumatic tools are not maintained in maintenance.
2. Pneumatic stripping machine is different from other pneumatic tools. After one week of running-in period, and keep the chain and sprocket unimpeded sliding at any time, add a few drops of gear oil to the chain every half working day to reduce friction. Extend its use time.
3. First make sure that the machine is connected to the gas source to ensure that the air pressure is 6-8 kg, and the air pipe is required to work at 8*12M/M.
4. Before the air pressure is not opened, drive the chain by hand, whether it can roll freely, otherwise it can't be used. After adjusting the direction of the paper-cutting machine, fix the locking screw 38#. Make it unable to swing.
5. Open the slide switch 01#. or the front pressure regulator to the maximum before working.
6. Inject professional pneumatic tool oil from the air inlet to lubricate the motor.
7. Press the platen 3# during work to start working.
8. Every day before and after work, be sure to drop three to four drops of special oil for pneumatic tools from the air inlet and idle for 2-3 seconds.